Centrifugal Pump 2D 3″x3″

Centrifugal Pump 2D 3″x3″

– Ideal for agriculture irrigation.
– Suitable for water supply system.
– Water supply for industries.

– These are horizontal, single-stage, single-suction, volute casing with central delivery. No need for air-release cock.
– Low NPSHR characteristic, hence pump can suck water from maximum depth.
– High efficiency, high discharge rate at less power consumption with central delivery pump, and side delivery pump.
– Extremely simple construction, easy maintenance, easy gland packing replacement.
– Compact and lightweight.
– Quiet operation and no vibration -long trouble-free service.

– The latest casing technique ensures smoothness of hydraulic passage resulting in high efficiency and reliability.
– Impeller
– The enclosed type, accurately machined impeller is statically balanced.

The high tensile carbon steel shaft is accurately machined and the ground is supported by two antifriction bearings in case of a double ball bearing pump and one journal bearing as well as one ball bearing in the case of a single ball bearing pump. This takes all the radial and axial load.

The stuffing box is sealed by gland packings. More stuffing box depth was provided for better sealing against air leakage. Water sealing is provided in the stuffing box.

High-quality anti fraction bearings lubricated by grease (lithium-based grease servojem-3).

Pumps are suitable for coupling to an electric motor or engine directly or through a belt drive.

– To get the best performance using the best frictionless pipes and foot valves.
– The suction pipe should be as short as possible.
– The weight of the suction and delivery pipe should not be applied to pumps.
– The pump should be carefully aligned during its installation.
– The pump should not be operated dry.
– The gland should not permit more than 30 drops per minute, if it does please tighten it.

tabel